Brush Tip: Protecting Your Brush Tips!

While shopping in a local DIY shop over the weekend, I spotted rolls of tubing meant for indoor water and aquariums. They were out of 3mm diameter tubing, but I bought a meter of 4mm tubing. This cost less than £1, so I’d expect the cost to be under $1/€1 depending where you are.

I thought these would be perfect for replacing the tubes that come on the ends of new brushes, and I was right! Even though the tubing I bought has a good bend to it (it was the very end of the roll, so the tubing was quite bent), the bend doesn’t affect the points of the brushes after they’ve been cleaned and shaped.

Hopefully that’s a bit of help for anyone looking to protect your brushes while they’re stored away 🙂

Leave a Reply

Your email address will not be published. Required fields are marked *

Time limit is exhausted. Please reload CAPTCHA.